Each service below can run standalone or as part of a full turnkey program — most of our OEM accounts use us for the entire process chain.
3 and 4-axis machining for shafts, housings, and machined brackets, held to ±0.02mm on critical features with full SPC logging.
Prototype through production tooling for stamped brackets, plates, and structural components, up to 200-ton press capacity.
Case hardening, through hardening, tempering, and induction hardening lines, batch-tested against your material spec.
Zinc and zinc-nickel plating, black oxide, and shot peening, chosen to meet your corrosion and fatigue requirements.
Multi-part sub-assembly and line-side kitting, so components arrive ready to install rather than needing rework at your facility.
Full PPAP packages, CMM inspection reports, and dimensional traceability supplied with every production lot.
This is the actual sequence a new component follows from your drawing to your first production shipment.
We review your drawing for manufacturability and flag anything that will be difficult to hold in production, before quoting — not after.
You receive a costed quote and a tooling plan within 3 working days, including lead time for any new tooling required.
We produce and inspect first-article samples against your drawing, with a full dimensional report for your sign-off.
Full production part approval process documentation is submitted for your quality team's review ahead of volume production.
We ramp to your forecast volume in agreed steps, with buffer capacity built in so early-stage variability doesn't hit your line.
Ongoing production runs with statistical process control on critical dimensions, and a named engineer as your single point of contact.